ALTO KIT #26757
	E4OD AND C-6 POWERPACK® CLUTCH KIT FOR THE DIRECT CLUTCH (THIRD & REVERSE)

CONTENTS OF CLUTCH KIT INCLUDE THE FOLLOWING: (8) FRICTION PLATES (.062") #26712A, (8) STEEL PLATES (.059") 26701A, (1) STEEL (.090") #26717A, (1) TOP PRESSURE PLATE (.125") #26713, (1) HEAVY DUTY TOP SNAP RING (.094") #26251-094

 

The contents of this Powerpack® will allow you to increase the friction plate capacity to address the above listed complaints. The additional capacity not only increases clutch pack performance and durability but also offers more resiliency in addition to a significant increase in torque holding ability.

INSTALLATION INSTRUCTIONS

FOR E4OD WITH ORIGINAL FOUR PLATE DRUM: Install SEVEN friction plates and SEVEN steel plates in the conventional manner. Install the top pressure plate and snap ring furnished.

FOR E4OD WITH ORIGINAL FIVE PLATE DRUM: Install EIGHT friction plates and EIGHT steel plates in the conventional manner. Install the top pressure plate and snap ring furnished.

FOR C-6 WITH ORIGINAL THREE PLATE DRUM: Install FIVE friction plates and FIVE steel plates in the conventional manner. Install the top pressure plate and snap ring furnished.

FOR C-6 WITH ORIGINAL FOUR PLATE DRUM: Install SEVEN friction plates and SEVEN steel plates in the conventional manner. Install the top pressure plate and snap ring furnished.

TECHNICAL COMMENTS: An .090" steel plate is furnished in this kit. To obtain the recommended clutch clearance of .020" - .025", it may become necessary to replace (1) .059" steel and/or install the original top snap ring.

Instruction Book (TOC)